Remote Control Batteries Installation - Canon LV-7555 Owner's Manual

BEFORE OPERATION
ZOOM BUTTON
Used to adjust zoom.
(P21)
FOCUS BUTTON
Used to adjust focus.
(P21)
MUTE BUTTON
Used to mute sound.(P22)
KEYSTONE BUTTON
Used to correct keystone
distortion. (P21, 37)
NO SHOW BUTTON
Used to turn the picture
into black image. (P22)
AUTO PC ADJ. BUTTON
Use to operate AUTO PC
Adjustment function. (P25)
WIRED REMOTE JACK
When using as the Wired
Remote Control, connect
the Remote Control Cable
to this jack.
Battery installation is
required when using as the
Wired Remote Control.
Remove the battery
1
compartment lid.
Press the lid down-
ward and slide it.
To insure safe operation, please observe the following precautions :
G Use (2) AA, UM3 or R06 type alkaline batteries.
G Replace two batteries at the same time.
G Do not use a new battery with an used battery.
G Avoid contact with water or liquid.
G Do not expose Remote Control Unit to moisture, or heat.
G Do not drop Remote Control Unit.
G If a battery has leaked on Remote Control Unit, carefully wipe the case clean and install new batteries.
G Danger of explosion if battery is incorrectly replaced.
G Dispose of used batteries according to batteries manufacturers instructions and local rules.
16
POWER
ZOOM FOCUS VOLUME
Used to adjust volume.
(P22)
D.ZOOM BUTTON
D.ZOOM
MUTE INPUT Used to select DIGITAL
ZOOM +/– mode and
resize image. (P29)
MENU BRIGHT
Used to enhance picture
brightness. (P22)
LASER
KEYSTONE
Used to freeze the picture.
LENS SHIFT
NO SHOW FREEZE
(P21)
AUTO PC ADJ. IMAGE
Used to select image
P-TIMER
level. (P28, 32)
Used to select LENS
SHIFT function. (P21)

Remote Control Batteries Installation

Slide the batteries into
2
the compartment.
Operating Range
Point Remote Control Unit toward
projector
VOLUME BUTTON
whenever pressing any button.
Maximum operating range for
Remote Control Unit is about 16.4'
(5m) and 60° in front and rear of the
projector.
BRIGHT BUTTON
FREEZE BUTTON
IMAGE BUTTON
LENS SHIFT BUTTON
Two AA size batteries
For correct polarity (+
and –), be sure the
battery terminals are in
contact with the pins in
the compartment.
(Receiver Window)
16.4'
(5 m)
60°
60°
16.4'
(5 m)
Replace the compartment
3
lid.