Table of Contents
Advertisement
9. CONNECT TO ASSIST FROM THE STUDIO OR MANAGEMENT SUBNETS
Assist may be accessed via the front-facing
port may not be connected to a local area network (LAN) and in a studio install scenario may not therefore be readily accessible to
an operator or engineer's PC. It is therefore recommended that the PC accessing Assist is now connected to the network switch
that serves the surface panels instead. By default, all user interfaces may be accessed via the rear network interfaces, using either
a "Management" or a "Studio A" subnet. The "Management" subnet resides in the
access to all applications and services running on the core. The "Studio A" subnet resides in the 172.17/16 address space
and provides access to the Assist, Core Configure & Calrec Connect applications, as well as the console control service.
Note: Type R is designed to support a Touch Interface if the PC provides this.
To use either subnet configure your PC's ethernet adaptor as follows:
•
Management - IP address 172.29.0.1, subnet mask 255.255.0.0
• Studio A - IP address 172.17.0.1, subnet mask 255.255.0.0
Note: Default "Studio B" and "Studio C" subnets will be added in a later version
Assist, Core Configure & Calrec Connect applications
To access the
corresponding IP address shown in the table below into the Google Chrome address bar address bar.
IP ADDRESSES FOR ACCESS TO ASSIST, CONNECT, SOFTWARE UPDATER & CONFIGURE USER INTERFACES
Application
Assist
Calrec Connect
Software Updater
Configure
16 TYPE R
Radio Production System
Setup
port by navigating to
Setup Port
(front of core)
172.16.255.25
172.16.255.60
172.16.255.40
172.16.255.19
172.16.255.25
in Google Chrome, however the Setup
172.29/16
, from the various connection points in the system type the
Management subnet
(back of core)
172.29.1.1
172.29.1.21
172.29.1.22
172.29.1.23
address space and provides
Studio A subnet
(surface panels)
172.17.1.1
172.17.1.21
172.17.1.22
172.17.1.23
Start Up Guide
Advertisement
Table of Contents
