Table of Contents
Advertisement
Artel Switch Management Settings for AoIP / AES67 Networks
The Artel ARG switch is used for AoIP/AES67 Interfacing and needs to have its Port Power Savings Configuration Properties disabled,
this is carried out in the Configuration>Green Ethernet>Port Power Savings page of the switch.
The Artel switch's default IP address is 192.168.100.100 typing this into the address bar of the browser accesses the Log in screen.
The default Username is "admin" and there is no default Password, clicking on the 'Sign in' button gives access to the switch's
configuration pages. A new Artel switch has its power saving feature disabled by default but it's worth checking, to ensure this is the
case, if it isn't then proceed as shown below:-
ARTEL ARG QUARRA SWITCH GREEN ETHERNET PROPERTIES PAGE
Deselect all the tick boxes as shown above on the Port Power Savings page of the switch and click on 'Save' to apply the changes.
Then go to Maintenance > Configuration > Save start-up-config and click Save Configuration. This will save the currently running
settings that you have just configured as the switch's startup configuration so that it loads whenever it is turned on or rebooted.
Cisco and Artel Switch and Network Configuration for AoIP / AES67 Networks
Below are shown some useful links for AoIP / AES67 network configuration, if using a Cisco SG350 switch for AoIP (which are only
recommended for very small systems) then please refer to the Cisco Auto Configuration guides or Cisco Manual Configuration guides.
These can be found at
https://calrec.com/resources/
For larger PTP based audio networking using Artel ARG Quarra switches please refer to the Artel links below:
Artel ARG Quarra PTP switch range
http://www.artel.com/media-transport-products/quarra
Artel ARG Quarra Configuration Guide for AES67
http://www.artel.com/-/media/products-related/configguides/quarra-configuration-guides/quarra-configuration-guide-for-aes67.
ashx?la=en
* In order to simplify configuration, a text based example configuration file can be uploaded for both the Cisco and Artel ARG
Quarra Switches for use with AoIP/AES67 Network devices. These can be found at
The configuration files both allow the switch to operate in the 192.168.30/24 for Primary AoIP port and 192.168.31/24 Secondary
AoIP port address ranges and can be adapted as required.
12 TYPE R
Radio Production System
https://calrec.com/resources/
.
Start Up Guide
Advertisement
Table of Contents
