Advertisement
Operating Instructions
Control Panel
TIMER indicator
FULL indicator
TIMER
SWING
DOWN
button
button
button
Icons
Press POWER to turn the product on and off.
POWER
MODE
When product is on, press MODE to choose among different modes.
When operating in DEHUMIDIFY mode or TIMER function, press UP or
UP/DOWN
DOWN to select desired humidity level or set the timer.
SWING
When product is on, press SWING to turn Swing function on or off.
TIMER
Press TIMER to set, check and cancel timer.
DEHUMIDIFY
indicator
ANION indicator
DRY indicator
UP
MODE
POWER
button
button
button
Function
P.8
Operating Instructions
Before Initial Use
Remove all accessories from the packing and water tank:
1. Remove the water tank from the product.
2. Take out the plug and other accessories.
3. Correctly reinsert the water tank into the product.
Note:
During operation, warm air exhausting from the top of the unit is a normal phenomenon. It is not a
malfunction.
Dehumidify Mode
When the product is turned on, press
until DRY Indicator lights up. Then press
humidity level between 35%RH - 80%RH. Display Panel will show the setting humidity for 3 seconds,
then panel will display the ambient humidity. When ambient humidity is lower than set humidity,
compressor will stop running, and fan will continue to run.
Continuous Dehumidify Mode
In Dehumidify Mode, press press
until Display Panel shows " " , after which the product will run
continuously until it is manually turned off.
Anion Mode
When the product is turned on, press
until ANION Indicator lights up. The screen display below:
Note:
In Anion Mode, the compressor does not run, and Dehumidify function is inactivated.
or
to select
P.9
Advertisement
