Quick-Start Guide - APRILIA eSR2 User Manual

• When you use it for the first time, charge the scooter to 100%.
• Press the power button for a few seconds to start it.
• Check the battery indicator, if the battery is low, recharge it before use, the electric
scooter is a device that requires periodic charging to work.
• Check the tyre pressure (36 PSI) if the scooter has not travelled at least 60% of the
stated km or reached the maximum speed in the first 3 months of use, it is likely that the
wheels have deflated again, it will thus be necessary to restore the pressure as indicated.
• Place the scooter on a flat surface.
• Put your hands on the handlebar. Step onto the footplate with one foot and use the other
to give yourself a gentle push and accelerate.
NOTICE
The accelerator is activated once the forward speed exceeds 3 km/h.
For safety reasons, the scooter is initially set up to avoid a standing start.
• When the scooter begins to move, place both feet on the footplate and press the
accelerator.
• To drive the scooter, tilt your body in the direction of travel when turning and slowly turn
the handlebars.
• To stop the scooter, release the accelerator and press the electronic or lever brake on the
left side of the handlebar.
• To dismount, first stop the scooter completely. Trying to get off the scooter while it is in
motion can cause injury.
• When you want to change speed mode, click the ON/OFF button (button B in
chapter 5).
• When driving at night or in dark places,double click the ON/OFF button to turn on the
lights, and wear a reflective vest.
For your own safety, wear a helmet and knee pads to protect yourself against falls and
injuries while learning to ride the electric scooter.
The rider assumes all risks for not wearing a helmet or other protective gear.
Always respect the traffic code and traffic-related rules and regulations that are applicable
to cyclists in the country of circulation.

2. Quick-start guide

04