Recalling The Memory Data; Deleting Data Stored In Memory - A&D Life Source UB-525CN Instruction Manual

Recalling the Memory Data

Note: This device stores the last 60 measurements in memory.
1. Press the button when turning the device off. The average of all
measurements and the number of data are displayed. If no data, "0" is
displayed. Press the
2. Use the following buttons to display data (of number and measurement data).
The device displays the average of all measurements and the number of
q
data are displayed.
Pressing the button each time , the device displays as follows:
q
• Average data of all measurements taken between.
• Data (of number and measurement data). The device displays in order
from most recent data.
In the example: No.30 & data
3. If you press the button after oldest data is displayed, the device proceeds to
step 1, the average of all measurements and the number ofdata are displayed.
4. Press the START button to turn the device off. After one minute of
non-operation, the device will turn off automatically.

Deleting Data Stored in Memory

Press and hold the button until turning off the device automatically. The device
displays the mark, deletes data stored in memory while blinking the
turns off automatically.
E-14
or START button to turn the device off.
No.29 & data
...
No.01 & data.
mark and
Memory mode
Average of all the data
Number of all data
Ex.: No.30
Most recent data
Last data (Oldest)
Turn off
button
button
button
button
Turn off