Related Manuals for Genvex Vanvex Lite Optima 150
Summary of Contents for Genvex Vanvex Lite Optima 150
- Page 1 User Manual Vanvex Lite Optima 150 Domestic Hot Water Heat Pump Version 1.03 - 0310...
- Page 2 Table of contents Page 1. Users Guide 1.1 Use ................3 Altering of the operation data.........3 1.3 Operating menu .............4 1.4 Factory default scheme ..........4 2. Function 2.1 Description Optima150 ..........5 2.2 Extra capacity ..............5 2.3 Operation safety ............5 2.4 Warnings ...............5 3.
- Page 3 1. Users guide P5: Operating thermostat for the electrical cartridge Optima 150 comes with a factory setup, which enables an The sanitary water temperature may be adjusted immediate start of the unit. The factory setup is basic and between 0 - 65 °C. The electric cartridge solely must be adjusted to the operational requirements and heats the top half of the container, while the heat demands of the individual home, in order to obtain the...
- Page 4 1.3 Operating menu 1.4 Factory default scheme E0: Factory setup Factory setup: Datum Datum If the system does not function as expected, even though E0: Factory setup 0 the setpoints have been adjusted, and the cause is impossible to locate, it is recommended to note down the Disinfection function ON/OFF settings in the schedule.
- Page 5 Pressure switch error: more water. It is possible to set the desired temperature When the high pressure switch trips, the red Genvex logo to which the electrical cartridge should heat up the water. will flash until the red pressure switch is reset.
- Page 6 Also check that the see if water comes out of the valve. Damage caused condensate drain is not blocked. by a blocked safety valve is not covered by the Genvex warranty. Environmental considerations...
- Page 7 4. Fault finding The heat pump is equipped with the following safety devices: 4.1 High pressure switch: The high pressure switch protects the heat pump against too high pressure in the cooling circuit. In case of interruptions (too high pressure) the red light in the control panel will flash and the high pressure switch will stop the heat pump.
- Page 8 Tel.: + 385/ (0) 1/ 65 45 407 Fax: + 385/ (0) 1/ 65 45 409 E-Mail: pichler@zg.hnet.hr Portugal Iberterm PT-4475-493 Nogueira Maia Tel: +351 229 065 123/4 Fax: +351 229 065 125 E-Mail: paulo.neto@iberterm.com Web: www.iberterm.com Published by Genvex A/S, Sverigesvej 6, DK-6100 Haderslev www.genvex.dk...
Need help?
Do you have a question about the Vanvex Lite Optima 150 and is the answer not in the manual?
Questions and answers