Initial Setup; Operation; Inflating - ETEKCITY EAM-DT1 Manual

Initial Setup

Remove the mattress from its packaging. Unfold
1.
the mattress and place it with the felt side facing
up.
2. Inflate the mattress (see page 9).
3. Let the mattress rest for 8–12 hours before
sleeping on it for the first time. Optionally, allow
the fully-inflated air mattress to air out for
several days in a well-ventilated room.
4. Allow the mattress to air out for 2–3 days in a
well-ventilated room.
Note: PVC material may have a strong smell
when new. This smell is normal and non-toxic. The
mattress materials have passed US CA Prop 65 tests
on lead, cadmium, and phthalates.
Figure 1.1

Operation

Inflating

1. Open the power cord storage compartment and
connect the plug to a 110V–120V AC outlet.
2. Make sure the manual air valve is fully closed.
[Figure
Note: The manual air valve has 2 parts. Make sure
both parts are closed, or the built-in air pump will
not work. If there is a hissing sound or air coming
from the valve, it is not fully closed.
Turn the control dial clockwise to "Inflate".
3.
[Figure
Note: Inflation will take about 2 minutes for the
twin-sized mattress, and about 3 minutes for the
queen-sized mattress. Time may vary based on the
environmental temperature.
Figure 1.2
1.1]
1.2]
9