American Standard Elevate AM00837400 Owner's Manual page 12

7
INSTALLING INTERIOR WHEELS, INTERIOR DOOR PANEL AND BOTTOM GUIDE B
• In this step, you'll need following parts: [9] x2, [12] x1, [22] x1
• In this step, you'll need the following tool: D
NOTE: TWO PEOPLE REQUIRED
7a. Remove metal nut from Interior Wheel [9] using supplied Wrench [7]. Separate metal and plastic nut and
place threaded end of Interior Wheel into outside hole of Interior Door Panel [22] keeping the 2 clear
plastic washers together on the wheel side. Place plastic nut and metal nut over threaded end of Interior
Wheel. Install second Interior Wheel on opposite side of panel in same manner. (ref. illustration)
7b. Tighten metal nut on Interior Wheel [9] using supplied Wrench [7]. An additional wrench may be
required to hold the plastic nut in place.
! CAUTION: Do not over tighten metal nut or possible damage to glass panel may exist.
7c. Hang Interior Door Panel [22] from inside of shower or tub onto inside groove of Top Rail [22]. A notch
exists in the Top Rail to allow Interior Wheel to enter groove of Top Rail.
7d. Slide Bottom Guide B [12] under bottom of Interior Door Panel [19].
7e. Move Bottom Guide [12] and Interior Door Panel [22] over Bottom Guide A [11] and snap Bottom Guide B
[12] into Bottom Guide A [11] until both are securely in place. (ref illustration)
7a
[22]
[9]
7b
D
7c
7d
[12]
7e
[7]
[22]
View from
inside
[22]