Notices; Warnings And Cautions - Honeywell Pro-Watch 7000 Install Manual

Notices

Warnings and Cautions

Wiring methods shall be in accordance with the National Electrical Code (ANSI/
NFPA70), Canadian Electrical Code, Part I (CSA C22.1) Safety Standard for Electri-
cal Installations, local codes, and the authorities having jurisdiction.
Warning:
Before connecting the device to the power supply, verify that the output voltage is within
specifications of the power supply.
Not Evaluated by UL for fire, life safety, or burglary applications.
Do not apply power to the system until after the installation has been completed. Personal
injury or death could occur, and the equipment could be damaged beyond repair, if this
precaution is not observed!
Warning: Fire Safety and Liability Notice
Never connect card readers to any critical entry, exit door, barrier, elevator, or gate without
providing an alternative exit in accordance with all fire and life safety codes pertinent to the
installation. These fire and safety codes vary from city to city and you must get approval from
local fire officials whenever using an electronic product to control a door or other barrier. Use of
egress buttons, for example, may be illegal in some cities. In most applications, single action
exit without prior knowledge of what to do is a life safety requirement. Always make certain that
any required approvals are obtained in writing. DO NOT ACCEPT VERBAL APPROVALS,
BECAUSE THEY ARE NOT VALID.
Honeywell never recommends using the PW-7000 or related products for use as a primary
warning or monitoring system. Primary warning or monitoring systems should always meet
local fire and safety code requirements. The installer must also test the system on a regular
basis by instructing the end user in appropriate daily testing procedures. Failure to test a
system regularly could make the installer liable for damages to the end user if a problem
occurs.
PW-7000 Two-Reader Module Installation Guide, Document 800-25676V1 iii