Brother Computerized Sewing and Quilting Machine Operation Manual page 13

NAMES OF MACHINE PARTS AND THEIR FUNCTIONS
■ How to Assemble the Spool Stand
a
Fully extend the telescopic thread guide shaft,
and then rotate the shaft until the two stoppers
click into place.
b
Insert the telescopic thread guide into the round
hole at the center of the spool support, and then
use a screwdriver to securely tighten the screw
from the reverse side.
a Screw
Note
Make sure that the stoppers on the telescopic thread
guide shaft are firmly in place and that the top of the
thread guide is parallel to the spool support. In addition,
check that the shaft is straight up from the spool support.
12
c
d
a
e
Firmly insert the two spool pins into the two
holes in the spool support.
Open the upper cover of the machine. With
your right hand, snap the cover toward the back
to release the cover from the latch. Slide the
upper cover to the right so that the pin on the
left side is disengaged, and then remove the
upper cover.
b
a
a Latch
b Pin
Raise the latch on the machine toward you.