Lcd Messages - Canon imageCLASS MPC190 Basic Manual

LCD messages

Message
BLACK INK CHANGED?
BLACK INK LOW
CANNOT START
CARTRIDGE JAMMED
CHECK PAPER SIZE
CHECK PRINTER
(PRESS RESUME KEY)
CLEAR PAPER JAM
(PRESS START KEY)
COLOUR INK CHANGED? The machine is prompting you to
Chapter 9
Cause
The machine is prompting you to
confirm whether you replaced
the black ink tank.
The ink level in the black ink tank
is low.
The USB cable became
disconnected while printing
from your computer.
The printhead holder cannot
move. This is normally due to a
paper jam.
The size of the paper in the
multi-purpose tray and that
specified in the paper size
setting are different.
There may be an obstruction
that is not allowing the
printhead holder mechanism
to move.
The waste ink tank (which holds
the ink used for printhead
cleaning) may be full.
There is a paper jam.
confirm whether you replaced
the colour ink tank.
Action
If you replaced the black ink tank,
press [2]. If you did not, press [3].
Make sure you have a new black ink
tank ready to replace the used one
when it runs out. If the machine stops
printing when copying, press
[Resume] to continue printing.
However, note that ink may run out. If
print quality deteriorates or output is
blank, replace the ink tank.
Wait for approximately one minute. If
nothing happens, reconnect the USB
cable. Then disconnect and reconnect
the power cord.
Clear the paper jam or whatever is
obstructing the printhead holder and
then press [Resume]. Do not attempt
to move the printhead holder
manually.
Load the correct paper size or change
the paper size setting. Then press
[Resume].
Check for any obstruction (paper clip,
small object, etc.). Check also for a
paper jam and clear the jam if
necessary. Then press [Resume] and
start again. If the message does not
clear after pressing [Resume], contact
your local authorised Canon dealer or
the Canon help line.
Contact your local authorised Canon
dealer or the Canon help line to have
the waste ink tank replaced
immediately.
Clear the paper jam and reload paper
in the multi-purpose tray. Then press
[Copy/Start] or [Resume].
If you replaced the colour ink tank,
press [2]. If you did not, press [3].
Troubleshooting
Details
p. 8-4
p. 8-1
p. 9-9
p. 3-8
p. 3-7
9
p. 9-9
p. 9-9
p. 3-8
p. 8-4
9-11