Aligning the printhead
To align the printhead after you have just installed it, follow the procedure in the Setup Sheet.
If you have printed the nozzle check pattern (
needs aligning, align it from the operation panel or from the MultiPASS Suite software.
Aligning the printhead from the operation panel
Follow this procedure to align the printhead from the operation panel:
1
Load A4- or letter-size plain paper in the multi-purpose tray.
2
Press [Menu] repeatedly until <MAINTENANCE> is displayed.
3
2 ] or [3 3 3
2
Use [2 2
4
Press [OK].
• The machine prints a horizontal pattern.
5
In column A on the printout, note which box has the most solid image. Note the value
next to this box and use [2 2
6
Press [OK].
7
Repeat steps 5 and 6 for columns B to F.
Aligning the printhead from the MultiPASS Suite
Follow this procedure to align the printhead from the MultiPASS Suite software:
1
Load A4- or letter-size plain paper in the
multi-purpose tray.
2
On the Windows desktop, click [Start],
point to [Settings], then click [Printers]
(Windows XP: Click [Start], then click
[Printers and Faxes]).
Chapter 8
3 ] to select <ALIGN PRINT HEAD>.
2 ] or [3 3 3
2
3 ] to enter it.
BAD
SAMPLE
Least solid
box
GOOD
SAMPLE
Most solid
box
p. 8-6) and determined that the printhead
Maintenance
8
8-7