Canon imageCLASS MPC190 Basic Manual page 74

Message
COLOUR INK LOW
COVER OPEN
DATA IN MEMORY
CANNOT TURN OFF
INK TANK CHANGED?
INVALID KEY/SETTING
LOAD PAPER
(PRESS START KEY)
MACHINE IN USE
CANNOT TURN OFF
MEMORY FULL
PUT IN CARTRIDGE
WAIT COOLING
WASTE INK NEAR FULL
WRONG CARTRIDGE
9-12
Troubleshooting
Cause
The ink level in the colour ink
tank is low.
You opened the inner cover
during an operation.
You are unable to turn the
machine off with the [ON/OFF]
key because the machine is
performing an operation.
You opened the inner cover.
An invalid key was pressed or an
invalid setting was selected.
The multi-purpose tray is empty. Load paper in the multi-purpose tray.
You are unable to turn the
machine off with the [ON/OFF]
key because the machine is
performing an operation.
The machine's memory is full
because you tried to copy too
many pages at once or a very
detailed document.
There is no printhead installed in
the machine.
During printing, the printhead
may have become too hot.
The waste ink tank is nearly full.
The printhead is not installed
correctly.
Action
Make sure you have a new colour ink
tank ready to replace the used one
when it runs out. If the machine stops
printing when copying, press
[Resume] to continue printing.
However, note that ink may run out. If
print quality deteriorates or output is
blank, replace the ink tank.
Close the inner cover.
Wait until the machine has finished,
then turn off the machine.
If you replaced an ink tank, press [2].
If you did not, press [3].
Check the key or setting you want to
enter.
Make sure the stack is below the
paper limit mark (| t ). Then press
[Copy/Start] or [Resume].
Wait until the machine has finished,
then turn off the machine.
Divide the document and copy each
part separately.
Install the printhead.
Allow the machine to cool down. The
machine will resume printing when it
has cooled down.
If <CHECK PRINTER> then appears,
contact your local authorised Canon
dealer or the Canon help line.
Try to reinstall the printhead. If the
message remains in the LCD, the
printhead may be defective. Contact
your local authorised Canon dealer or
the Canon help line.
Details
p. 8-1
p. 8-3
p. 3-8
Setup
Sheet
Setup
Sheet
Chapter 9