An Error Message Appears On The Screen - Canon i9100 Quick Start Manual

Troubleshooting

An Error Message Appears on the Screen

Problem Possible Cause
Printer not ready
Error Writing /
Output to USBnnn
(or USBPRNnn)
Paper is not loaded Load paper and press the RESUME/CANCEL
Faulty connection
Printer driver is not
installed properly
Not enough
memory
"Error No.: X202"
Printer driver fault
"Error No.: X203"
Printer not ready
"Error No.: X300"
Printer not properly
connected
Printer not selected
in chooser
56
The power lamp flashes green when the printer is warming up, or when a print
job is being sent to the printer. It glows a steady (non-flashing) green when it is
ready for use or when the print job is completed.
RESUME/CANCEL button.
RESUME/CANCEL RESUME/CANCEL
Ensure the printer cable is securely connected to the computer.
Note If you are using a switching hub or other device, disconnect the
printer and reconnect it directly to the computer and try
printing again.
If successful, the problem may have been with the device.
There could also be a problem with the cable(s). Replace the
cable(s) and try printing again.
Uninstall then reinstall the printer driver.
1. Click Start Start, select All Programs All Programs (or Programs
Start Start All Programs All Programs
2. Follow the on-screen instructions to uninstall the driver.
Follow the procedures described in the
the printer driver.
Increase available memory by closing any other applications currently running.
The printer driver may not be installed correctly. Uninstall, then reinstall the
printer driver.
User's Guide
Refer to the for instructions on how to uninstall the printer driver.
If the POWER lamp is off, turn the printer on.
If the POWER lamp is flashing green, the printer is initializing. Wait until the
POWER lamp stops flashing.
Ensure the printer is securely connected to the computer.
Note If you are using a switching hub or other device, disconnect
the printer and reconnect it directly to the computer and try
to print again.
If successful, the problem may have been with the device.
There could also be a problem with the cable(s). Replace the
cable(s) and try printing again.
1. From the Apple Apple menu, select Chooser
Apple Apple
2. Click the i9100 i9100 icon and ensure that the i9100 is selected as the target
i9100 i9100
connection.
If not, select it.
Note If the problem persists, delete all unnecessary documents
from the Extensions and the Control Panels folder.
Try This
Programs), Canon Canon i9100 i9100, and Uninstall
Programs Programs Canon Canon i9100 i9100
Easy Setup Instructions
Chooser.
Chooser Chooser
Uninstall.
Uninstall Uninstall
and reinstall