Cannot Print Properly From The Digital Camera - Canon i475D Series Printing Manual

Cannot Print Properly from the Digital Camera

The following messages may be displayed on the digital cameras or digital video
camcorders when images are printed directly from them. Take the appropriate action
to correct the error.
This section describes error messages displayed when you are using a "Bubble Jet
Direct" compatible digital camera or a digital video camcorders.
Images can be printed directly from "PictBridge" or Canon "Bubble Jet
Notes
Direct" compatible digital cameras and digital video camcorders connected
to this printer. Refer to "Direct Printing from PictBridge-compatible Digital
Cameras" for more information about "PictBridge".
If the connected digital camera or digital video camcorder does not support
"PictBridge" or "Bubble Jet Direct", the Power
eleven times. If this happens, disconnect the connection cable and press the
Resume Resume Resume button. Resume
If the operation time or data transmission time is too long when the digital
camera or digital video camcorder is connected to this printer, a
communication time error may occur and no more images can be printed. If
this error occurs, press the Resume
The digital camera will automatically turn on. If not, turn it on.
A low ink warning is not displayed on the digital camera.
After replacing an ink tank, cancel the connection with the digital camera
and reset the ink counter. See "Reset the ink counter." on page 36.
If the ink counter is not reset, the remaining ink level may not be displayed
properly.
For more details, also refer to the user's manual for the digital camera or
digital video camcorder.
Error message on camera
Printer in use
Printer warming up
No Paper
Paper Jam
Printer cover open
No print head
Waste tank full
Paper lever error
Printer error
Resume Resume Resume button.
Images are printed from the computer. Wait until printing ends.
Wait until warm-up ends.
Load the paper in the printer and press the Resume
Remove the jammed paper, load new media, and press the Resume
Close the front cover.
No print head is installed. (The Power
Install a print head according to the Easy Setup Instructions.
The print head is defective. (The Power
Contact the Customer Care Center.
The waste ink tank is nearly full. Press the Resume
recover from the error. Contact the Customer Care Center as soon as possible.
Incorrect position of the paper thickness lever.
Open the front cover and adjust the paper thickness lever to the left position.
An error requiring servicing has occurred. (The Power
alternately orange and green.)
Turn off the printer, unplug the power cord from the power supply, plug the
power cord back in, and then turn on the printer. If the same error occurs, contact
the Customer Care Center.
Troubleshooting
Power lamp on the printer will flash Power Power
Try This
Resume Resume button on the printer. Resume
Power Power lamp on the printer flashes six times.) Power
Power lamp on the printer flashes seven times.)
Power Power
Resume button on the printer to
Resume Resume
Power lamp on the printer flashes Power Power
Resume button.
Resume Resume
41