Canon i475D Series Printing Manual page 39

Error Number/Problem
302 302 302 302
Paper jammed.
402 402 402 402
No print head is installed.
403 403
403 403
The print head is faulty.
611 611
611 611
A specified period of time has lapsed without
receiving a response from the digital camera.
612 612 612 612
This printer is not ready for the connected
digital camera or digital video camcorder.
802/804/806/807/808/809 802/804/806/807/808/809
802/804/806/807/808/809 802/804/806/807/808/809
An error requiring a service may have occurred.
If the Same Error Persists
Note
If the same error persists after a countermeasure is taken according to the
above error number, turn off the printer, remove the power cord plug from the
outlet, plug the power cord back in, and then turn on the printer again.
An Error Icon is Displayed on the Operation Panel.
Error Icon/Problem
stays lit.
The memory card is inserted
incorrectly.
is flashing.
The memory card cannot be read.
The ? ? ? ? mark is displayed beside the ink
tank icon.
An ink counter has not been reset
after replacement of the relevant ink
tank.
Remove the jammed paper, load paper, and press the Resume
Install the print head following the instructions given in the Easy Setup
Instructions.
Turn off the printer by pressing the Power
printer again.
If the same error persists, the print head may be faulty. Contact the
Customer Care Center.
Press the Resume Resume button.
Resume Resume
The digital camera will automatically turn on. If not, turn it on.
Disconnect the camera connection cable, press the Resume
then connect the cable once more.
If the error is still unresolved, there is a possibility that you are using a
digital camera or digital video camcorder that is not supported by this
printer.
Connect compatible digital cameras or digital video camcorders that are
compatible with this printer.
Turn off the printer, remove the power cord plug from the outlet, plug the
power cord back in, and then turn on the printer again.
If the same error persists, contact the Customer Care Center.
Insert an available memory card after checking its orientation. See "Using a
Memory Card" on page 8.
If a memory card has already been inserted, remove it and then insert it again.
Next, check that the Indicator lamp stays on.
Never remove the card while image data is being read (the
Note
Indicator lamp is flashing).
Image data edited/processed on the computer must also be printed from the
computer.
After replacing an ink tank with a new one, reset the relevant ink counter. See
"Replacing an Ink Tank" on page 34.
Troubleshooting
Try This
Power button, then turn on the
Power Power
Resume button, and Resume Resume
Try This
Resume Resume button. Resume
39