Advertisement
What is Standby? Refer to fig.5
4.5.
4.5.1.
When the media is not flowing through the meter, the meter shows only the word TOTAL on the display. This mode is called STANDBY
and majority of adjustments are carried out in this mode.
Note: Last dispensed quantity can be brought to zero by pressing and holding the RESET button.
4.6.
Measurement Units Configuration
4.6.1.
the user can select the main measurement unit: Quarts (Qts), Pints (Pts), litres (l), Gallons (Gal) according to the following
predefined combinations:
Ref.
Unit of measurement
no.
resettable batch total
1
litres (l)
2
Gallon (Gal)
3
Quarts (Qts)
4
Pints (Pts)
4.7.
Setting the Units of Measurement Refer to fig's 6 & 7.
4.8.
Wait for the meter to go into standby mode.
4.8.1.
Press the cAl and reset keys together, hold until the word "unit" appears on the screen together
with the current unit of measurement.
4.8.2.
Press RESET key to scroll among the four combinations of units of measurement as shown in fig.7.
fig.7
4.8.3.
Press CAL key for more than 2 seconds to store new settings. The METER will return to Standby Mode, see fig.8.
Note: No new calibration is required after changing the Unit of Measurement.
4.9.
Normal Dispensing Mode see fig.9
4.9.1.
While the media is flowing through the meter, Batch Total and Reset Total are displayed at the same time.
4.9.2.
A few seconds after dispensing has ended, the display switches from reset totAl to totAl: the word totAl disappears and the
Reset TOTAL is replaced by TOTAL, see fig.10.
Note: This situation, where only "TOTAL" is displayed, is called STANDBY mode.
It remains stable until the user operates the meter again.
© Jack sealey limited
fig.5
Unit of measurement
Batch totaliser
litres (l)
Gallon (Gal)
Gallon (Gal)
Gallon (Gal)
fig.8
Original Language Version
fig.6
fig.9
fig.10
tP101.V2 | issue:1 30/11/17
Advertisement
