Maintenance; After Each Use; Lubricate Before Storage - Craftsman C950-52844-1 Owner's Manual

PROCEDURE
Tighten all screws
and nuts
SNOWTHROWER
Check Clutch Cable
Adjustment (See
Cable Adjustment)
Oil, Check
ENGINE
Oil, Change
NOTE: The warranty on this snowthrower does not cover items
that have been subjected to operator abuse or negligence. To re-
ceive full value from the warranty, operator must maintain
snowthrower as instructed in this manual.
The above Service Recom mendations are supplied to assist the opera-
tor to properly maintain the snowthrower. This is a check list only. Adjust-
ment referred to will be found in the MAINTENANCE section of this manual.

AFTER EACH USE

1. Check for any loose or damaged parts.
2. Tighten any loose fasteners.
3. Check and maintain the auger.
4. After each use, remove all snow and slush off the snowthrower to
prevent freezing of auger or controls.
5. Check controls to make sure they are functioning properly.
6. If any parts are worn or damaged, replace immediately.
SERVICE RECOMMENDATIONS
FIRST BEFORE
2 EACH OFTEN
HOURS USE
✓ ✓
✓
✓
✓
19
EVERY EVERY
5 10
HOURS HOURS
✓

LUBRICATE BEFORE STORAGE

Lubricate chute control flange (A, Figure 16). Lubricate flange
with a clinging type grease such as Lubriplate.
A
Lubricate Chute Control Flange

MAINTENANCE

EVERY BEGINNING
BEFORE
25 EACH
STORAGE
HOURS SEASON
✓
✓
✓
✓ ✓
Figure 16
✓