Canon PIXMA MX700 Series Network Setup Manual page 24

Note
To confirm the machine's MAC address, display the
machine's network setting information referring to
"Displaying and Initializing Network Settings" in the
User's Guide on-screen manual.
For details on how to scan, refer to the User's
Guide and Scanning Guide on-screen manuals.
11
After the MP Drivers are installed, start up the
Canon IJ Network Tool to mount the Card Slot.
For details on the network setup of the Card Slot,
refer to "Using the Card Slot over a Network" in the
User's Guide on-screen manual.
2-B Setting up an additional LAN-connected
computer
This section describes how to set up an additional computer to use the machine over wired LAN,
when the machine has already been set up to connect to the network using another computer. This
setup procedure only requires settings to be performed on the additional computer.
1
Make sure that the machine is connected to
the network device with a LAN cable.
Note
If MAC or IP address filtering is configured to restrict
access to the machine, make sure beforehand to
register those addresses of the computer you are
setting up. To register the addresses, use the Canon
IJ Network Tool on the computer that has already
been set up.
Make sure that the computer you are setting up is
not connected to the machine with a USB cable.
This setup procedure does not involve connecting
the USB cable.
2
On the Canon IJ Network Tool screen,
select LAN connection, then click OK.
If the Canon IJ Network Tool does not start up
automatically, select Library > Printers > Canon >
BJPrinter > Utilities > Canon IJ Network Tool.
Note
If you select USB connection, the Canon IJ Network
Tool will exit without setting up the machine to be used
over LAN.
3
When the screen shown on the right appears,
click OK.
24