Canon PIXMA MX700 Series Network Setup Manual page 13

3
Confirm that the setup program detects the
machine automatically.
The machine connected to the network is detected
automatically.
Note
If the machine has not been detected, make sure of the
following, then click Update.
The machine is turned on and connected to the
network device with the LAN cable.
The machine is not set to use access control.
The firewall function of any security software is
turned off.
If the firewall function is turned on in Windows XP
with Service Pack 1 or earlier, a message asking
whether to turn the firewall function off is displayed
during setup. If it is displayed, click Yes to turn it off.
The firewall function is turned back on automatically
after setup is complete.
– For information on how to confirm Windows XP
Service Pack versions, refer to "Checking
Information about the Network" in
"Troubleshooting" in the User's Guide on-screen
manual.
– Some programs that switch the network
environment depending on your system
environment will enable a firewall function by
default. Check the settings on any such software.
4
Select the machine on the Printers dialog
box, then click Next.
In Windows Vista, go to step 6.
In Windows XP and Windows 2000, go to step 5.
5
When the Network Setup of the Card Slot
dialog box appears, specify the drive letter,
then click Next.
Note
The Card Slot of the machine must be mounted to be
used as the memory card drive of the LAN-connected
computer.
To write files to a memory card, set the Read/write
attribute setting under Device settings to LAN
enabled. If the setting is set to USB enabled, you
cannot access the network drive of the Card Slot.
13