Easy To Rectify Faults - OMT STAND.MOVE M1.0 Operation Manual

11 Easy to rectify faults

Warning: Before troubleshooting, especially on faulty cables, the controller must be
isolated from the network.
If a fault cannot be rectified as described, isolate the product from the voltage supply, wait for at least 3
minutes and try again.
If the fault continues to occur, isolate the product from the voltage supply and contact our customer
service.
Table 1: Fault description of the faults that are easy to rectify.
Fault description
Table does not move
STAND: 17.06.2019
Troubleshooting
Check whether the desk has power.
Check the connection between the controller and the
hand switch. Restore the connections.
Powering-on duration exceeded. Wait until the
table is ready for use again (approx. 3 min.).
Hand switch faulty: Replace the hand switch
or contact customer service.
9910_Operation-Manual_STANDMOVE_M1-0_Rev1v0_EN Seite 18 von 23