Disassembly/Maintenance; Maintenance; Cleaning And Care - OMT STAND.MOVE M1.0 Operation Manual

10 Disassembly/Maintenance

1. Disconnect the controller from the mains.
2. Disconnect all the connections between the controller and the hand switch.
3. Dismantle the hand switch from the table.

Maintenance

Warning: Do not open the hand switch. Opening the controller will render all warran-
ties from OMT null and void.
Danger: If you find defective cables, immediately isolate the controller from the
mains.
Pull the mains plug.
Check the plug-and-connector joints at the controller regularly for firm fitting. Check all the cables
regularly for defects. If you find defective cables, plugs or loose plug-and-connector joints, replace the
cables. If that is not possible, or does not bring about any improvement, contact OMT customer
service

Cleaning and care

Warning: Aggressive cleaning agents can cause damage or discolouration on the
product. Therefore, only agents with a pH value of 6-8 may be used.
The Handswitch STAND.MOVE M1.0 can be wiped from the outside with a soft cloth. Coarse soiling
may only be removed with a soft, damp cloth. Ensure that no moisture penetrates into the housing.
STAND: 17.06.2019 9910_Operation-Manual_STANDMOVE_M1-0_Rev1v0_EN Seite 17 von 23