Operation; Height-Adjustment; Set And Delete Shelf And Container Stop - OMT STAND.MOVE M1.0 Operation Manual

9 Operation

Oelschläger Metalltechnik GmbH offers its customers various variants of the STAND.MOVE M1.0. All
our hand switch models are available with and without the logo printed on them. The functions described
can be used with all variants of the STAND.MOVE M1.0 model.
Caution: The upper end position of the desktop is pre-set in the controller.
For this reason, only those controllers that have been supplied as being suitable
for the respective desk base may be used.
In the operating manuals of the STAND.CONTROL C1 and C2 controllers, you will find a general de-
scription of the operation of the simple and well as comfort manual switches in conjunction with the
controller.

Height-adjustment

Note: When adjusting the height of the table, please ensure that no children
or other persons are underneath the table. There is a risk of injury.
Press the -button to lower the desktop. Keep the button pressed until the desktop has reached the
desired height. The table stops automatically as soon as the lower end position is reached (container-
stop, safety stop or minimal position).
Press the -button to raise the desktop. Keep the button pressed until the desktop has reached the
desired height. When the table reaches the upper end position or the pre-set shelf-stop, the movement
is ended.

Set and delete shelf and container stop

Warning: Only trained personnel should carry out setting and deletion of container
and shelf stops. There is a danger of injury from wrong setting or removal of the
Stop positions, and a danger of the table getting destroyed.
Note: This function is configuration-dependent and is not available with every
controller.
STAND: 17.06.2019
Figure 3: Hand switch STAND.MOVE M1.0
9910_Operation-Manual_STANDMOVE_M1-0_Rev1v0_EN Seite 15 von 23