Installation; Unpacking - OMT STAND.MOVE M1.0 Operation Manual

7 Installation

Unpacking

Note: When unpacking, ensure ESD-compliant handling of the electronic components.
Caution: Oelschläger Metalltechnik GmbH does not provide any warranty for faults
and damage to the device that are the result of electrostatic discharge.
For unpacking electronic devices, please proceed as follows:
1. Remove the packaging material.
2. Check the contents of the package for completeness:
3. Dispose of the packaging material in an environment-friendly manner, in accordance with the
applicable national regulations in your country. Recycle reusable packaging.
Installation
Install the table controller STAND.CONTROL C1 or C2 in accordance with the relevant manual. Install
the operating element STAND.MOVE M1.0 on the front table edge on the underside of the table-top
(see Figure 2).
You will need the following material and tools for the installation:
- Pencil
- Drill
- 2 screws
- Screwdriver in a size suitable for the screws
Note: Before fitting, the control system and the sensor must be electrically
deenergised.
Note: The screws are not included in the scope of delivery since they have to be
selected depending on the material and the thickness of the desktop.
There are holes with a diameter of 5.2 mm provided for this purpose on the hand
switch. Use fillister-head or cheese-head screws.
The tightening torque depends on the desktop material, but should not exceed 2 Nm.
STAND: 17.06.2019 9910_Operation-Manual_STANDMOVE_M1-0_Rev1v0_EN Seite 12 von 23