Turning The Machine On And Off - Canon PIXMA MP140 Series Quick Start Manual

Turning the Machine On and Off

Turn on the machine before printing.
Turning On the Machine
Before turning on the machine, confirm the following.
The FINE Cartridges are installed properly.
The machine is connected to your computer (or a compatible device).
The MP Drivers are installed.
Note
If preparatory operations above are not complete, follow your setup sheet to complete them.
1
Press the ON/OFF button.
The POWER lamp flashes and then remains lit
green.
Important
If the ALARM lamp begins to flash orange, see "An
Error Code Is Displayed on the LED" on page 37.
2
If you are using the machine connected to a
computer, turn on your computer.
Turning Off the Machine
1
To turn off the machine, press the ON/OFF
button.
When the POWER lamp stops flashing, the
machine is turned off.
Important
About the Power Plug
When removing the power plug after turing off the
machine, be sure to confirm that the POWER lamp is
not lit. If the power plug is removed from the wall outlet
with the POWER lamp still lit or flashing green, the
machine may become unable to print.
See "Keeping the Best Printing Results" on page 31.
To Save Energy
The LED goes out if the machine is not operated for about five minutes*.
Perform a print operation to restore the display.
*You cannot change the wait time before the LED goes out.
Note
When you want to restore the display, perform a print operation or press any button except ON/
OFF button. When you press the ON/OFF button while the machine is in Screen-saver mode, the
machine turns off.
4 Before Using the Machine