Operating The Machine; Feeding Material; Automatic Response In Case; Of „Overloading - Intimus 200 CP5 Operating Instructions Manual

GB

3 .2 Operating the machine

CAUTION!
Risk of injury!
The paper tray may not be used as a step
ladder or as a seat. Danger of tipping over!
To start, switch on the unit by operating the mains
switch (fig. 2). The pilot lamp marked „ready for ope-
ration" (fig. 3/4), as well as the red stop-button „S"
(fig. 3/2) will light to indicate that the machine is ready
for operation.

3 .3 Feeding material

CAUTION!
Damage to the machine!
Ì Never feed the shredder with a quantity
of paper exceeding the maximum indi-
cated in the „Technical data", p. 14.
Ì Should the machine be overfed, follow
the instructions under „Automatic res-
ponse in case of „overloading"", p. 12.
Feeding crumpled paper (model H200CP4 (852CC)):
1 . Fill the hopper with crumpled paper.
NOTE!
The crumpled paper can be dropped directly
from the wastepaper basket into the hopper
of the machine. The apportioning wings pre-
ceding the cutting mechanism ensure more or
less uniform distribution of the paper.
CAUTION!
Damage to the machine!
The wastepaper basket is no refuse tin and
should not be emptied into the machine
thoughtlessly - in no way can the machine
destroy bottles, pens, pencil sharpeners etc.
2 . Press the pushbutton switch „forward" (fig. 3/3).
¾ The cutting system runs and begins to shred the
paper.
NOTE!
Do not feed any smooth paper until the
crumpled paper is completely shredded.
3 . To switch the machine off press the red stop-but-
ton (fig. 3/2).
12
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
Feeding smooth paper:
1 . Feed smooth paper through the opening at the lo-
wer part of the hopper (Modell H200CP4 (852CC))
or through the opening of the hopper (Modell
200CP5 (802CC)) to the cutting system.
¾ Machine switches automatically to forward and
draws paper in.
¾ The machine switches off automatically after
shredding.
3 .4 Automatic response in case of
„overloading"
In case you accidentally overload the shredder, it will
automatically alleviate the problem as follows:
1 . The cutting system becomes jammed. The pilot
lamp (fig. 3/5) lights up.
2 . The cutting system runs briefly in reverse, thereby
freeing the material to be shredded.
3 . The cutting system automatically switches back to
forward mode.
The machine repeats this process until all the material
has been shredded satisfactorily.

3 .5 Emptying the collecting bag

1
2
1
Door
2 Sliding frame
3 Rubber band
fig. 5 Emptying the collecting bag
When the collecting bag is full, the machine turns off
automatically. The pilot lamp (fig. 3/6) lights up. Empty
the collecting bag as follows:
1 . Open the door and take out the sliding frame
(fig. 5/2) with the collecting bag.
2 . Remove the rubber band (fig. 5/3), take out the full
bag and dispose of contents.
3 . Put the empty bag from below through the sliding
frame and put the edges of the bag approx. 10 cm
over the frame outwardly.
4 . Fix the collecting bag with the rubber band at the
sliding frame.
5 . Move back the sliding frame with the collecting
bag and close door.
3
000295
82810 17 04/19