Control Panel Components; Assembly - Westinghouse WGen9500DFc User Manual

ASSEMBLY

CONTROL PANEL COMPONENTS

1
1. Fuel Selector Switch: Used to select gas or propane
operation.
2. Push-Button START/STOP: Push once to
automatically start the engine. Push again to stop
the engine.
3. Battery Switch: Turns battery ON and OFF. Must be
ON before electric or remote start.
4. Main Circuit Breaker: The main circuit breaker
controls total output of all outlets to protect the
generator from overload or short circuit.
5. Battery Charging Port: Used to charge the battery
with the included battery charger.
6. 120 Volt AC, 20 Amp Duplex GFCI NEMA 5-20R
Receptacles: Receptacles can supply a maximum of
20 Amps.
7. 120/240 Volt AC, 30 Amp NEMA L14-30R Twist-
Lock Receptacle: Receptacle can supply a
maximum of 30 Amps.
8. 120/240 Volt AC, 50 Amp NEMA 14-50R
Receptacle: Receptacle can supply a maximum
of 50 Amps.
12 | Westinghouse Outdoor Power Equipment, LLC
2
16 15
DATA CENTER
Voltage: Frequency (Hz):
Displays current voltage Displays power output
output. frequency in Hertz.
METER V-F-T
Push the Mode button to cycle through
the data display modes.
Mode Button
5
3 4
14
13 12
9. Ground Terminal: The ground terminal is used to
externally ground the generator.
10. 30 Amp AC Circuit Breakers: Circuit breakers
limits the current that can be delivered through each
leg of the NEMA 14-30R receptacle to 30 Amps.
11. 20 Amp AC Circuit Breakers: Circuit breakers
limits the current that can be delivered through the
NEMA 5-20R receptacles to 20 Amps.
12. 20 Amp AC Circuit Breakers: Circuit breakers
limits the current that can be delivered through the
NEMA 5-20R receptacles to 20 Amps.
13. Data Center: Toggle to show voltage, frequency,
total hour meter, and run/maintenance timer.
14. Smart Switch Outlet: Connects the Westinghouse
ST Switch (sold separately) to the control panel.
15. Battery Indicator: Indicates that power is ON. Light
will remain illuminated while the unit is ON.
16. CO Sensor indicator lights: The CO Sensor
monitors for the accumulation of poisonous carbon
monoxide gas. If increasing levels of CO gas are
detected, the CO Sensor automatically shuts down
the engine.
Lifetime Hours:
Displays the lifetime run
hours.
6 7 7
11 10
Run Time/Maintenance:
Displays current run time.
Resets to zero when shut
down. Maintenance
reminder displayed
when required.
Maintenance Codes:
P25: Change engine oil
P50: Clean air filter,
Change engine oil
P100: Change engine oil,
clean air filter, replace
fuel filter
8
9