Table of Contents
Advertisement
Figure 4.1
figure 4.1.
In order to re-place the oven door, perform the abovementioned steps in reverse.
CLEANING AND MAINTENANCE OF THE OVEN'S FRONT DOOR GLASS
Remove the profile by pressing the plastic latches on both left and right sides as shown in
figure 6 and pulling the profile towards yourself as shown in figure 7. Then remove the inner-
glass as shown in figure 8. If required, middle glass can be removed in the same way. After
cleaning and maintenance are done, remount the glasses and the profile in reverse order.
Make sure the profile is properly seated in its place.
Figure 6
RACK POSITIONS
Installing and removing wire racks
To remove wire racks, press the clips shown with arrows in the figure, first remove the lower,
and than the upper side from installation location.
To install wire racks; reverse the procedure for removing wire rack.
Figure 4.2
figure 4.2
Figure 7
It is important to place the wire grill into the oven properly. Do not
allow wire rack to touch rear wall of the oven. Rack positions are
shown in the next figure. You may place a deep tray or a
standard tray in the lower and upper wire racks.
20
Figure 5.1
Figure 5.2
figure 5.1.
figure 5.2
Figure 8
Advertisement
Table of Contents
