Getting Connected; Bandwidth Requirements; Wireless Lan Requirements; Network Equipment Placement And Power Requirements - Life Fitness Integrity SL Owner's Manual

4. Getting Connected

Bandwidth Requirements

The tables below shows the recommended bandwidth based on application.
Download
Number of Units
Up to 16 Integrity Products
17+ Integrity Products
Upload
Number of Units
20 Integrity Products
21+ Integrity Products

Wireless LAN Requirements

NOTE: A dedicated internet connection is recommended. You will need to allow traffic outbound without any filtering
or blocking on your internet connection.
Access Points
• Life Fitness recommends a maximum ratio of 20 Integrity Series products per wireless access point. Exceeding this
ratio introduces the potential of dropped workouts and connection issues.
• The Integrity SL Console requires a connection to a wireless network with SSID of LFwireless. If you purchase your
access point from Life Fitness (ACCESS-POINT-01), the access point will by default have this SSID installed. Contact
Life Fitness Customer Service at 1.800.351.3737 or your Life Fitness representative before setting up this network to
receive the required password for this SSID.
• When connecting Integrity Series products to wireless access points, see
recommended number of units and bandwidth.
• Commercial grade access points that meet the following minimum requirements:
• Wireless-N Access Point (802.11n) with 2x2 MIMO
• Band: 2.4 / 5 GHz Protocol: IEEE 802.11 n
• Security: WPA2-PSK
• Mounting: wall or ceiling mountable (e.g. Meraki MR32 or Rukus R500)
Cabling Requirements
• CAT 5e or CAT 6 cabling can be used to connect your wireless access points to your wired network. Life Fitness
recommends using CAT 6 cable for this purpose.

Network Equipment Placement and Power Requirements

Network equipment such as modems, wired routers and switches will require power; refer to product specs for exact
requirements. Each access point will need power via PoE (Power over Ethernet) or additional optional power adapter.
Refer to recommended manufacturer power requirements for further information.

Port Configuration

All traffic initiated from our consoles is outbound (i.e. data only flows out from our consoles). If you do not block
outbound traffic and the associated return traffic, then no additional configuration is needed. Otherwise, if your
network restricts outbound traffic, you need to open outbound connections on these specific ports:
• TCP/UDP port 80
• TCP/UDP port 443
• TCP/UDP port 1883

Destination URLs

The cardio machines will contact *.halo.fitness.com and *.s3.amazonaws.com.
Bandwidth Required
4 Mbps
4Mbps + 0.25 Mbps for each additional product
Bandwidth Required
512 Kbps
512 Kbps +512 Kbps per additional 20 products
Bandwidth Requirements
• TCP/UDP 8883
• UDP port 1194
Page 41 of 55
for the