Troubleshooting Guide - Braun MultiQuick 9 MQ9137XI Manual

Materials and accessories coming into
contact with food conform to EEC
regulation 1935/2004.

Troubleshooting guide

Problem
Hand blender does
not operate
Safety button light
solid red and imode
selector lights are all
flashing
Lid (with Gearbox)
cannot be closed
completely
Water in the Lid (with
Gearbox)
Water in one of the
tools (Dough tool,
Kneading hook,
Blade or Disc Axle)
24
5722114494_HB901-MQ9137XI-9199XL_USCA.indd 24 5722114494_HB901-MQ9137XI-9199XL_USCA.indd 24
Possible cause
No power
Device is overheated
Food is trapped between FPXL bowl
and lid (with Gearbox)
Tool is not inserted into the FPXL bowl
completely
Dicer only: The Dicer is not connected
to the Splash Guard or not connected
correctly
Dicer only: The Dicer is blocked by food
residues in the cutting grid
Is not connected correctly
Lid (with Gearbox) was accidently
immersed in water or placed in the
dishwasher
Leakage of the affected tool
Solution
Check appliance is plugged in.
Check the fuse /circuit breaker in your
home.
If none of the above contact Braun
Service.
Let the device cool down one hour. It is
ready for use again when the imode
selector light stops flashing and the
safety button light flashes.
Open the lid (with Gearbox) and remove
food residues
Turn the tool by hand while pressing
down slightly, until it locks in place
Attach the Dicer to the Splash Guard
before placing the Lid (with Gearbox) in
the FP bowl (observe the symbols for
correct alignment)
Open the Dicer and remove food from
the grid
Connect correctly
Remove rubber plug inside the coupling
for motor part. Drain the water. Replace
the plug. Caution: Water in the lid (with
Geabox) will damage the device. This
described method must therefore not
be used intentionally to place the lid
(with Gearbox) in the dishwasher
Contact a Braun service center for
replacement
01.04.21 08:56 01.04.21 08:56