Warranty And Service; Troubleshooting Guide - Braun PowerBlend 9 Manual

• When chopping solid ingredients (such as
parmesan, chocolate or meat) cut them up
into small pieces (3 cm).
(H) Care and Cleaning
We recommend cleaning the jug by using the
CLEAN program to prolong its lifetime. The
program will automatically stop once it com-
pletes the cycle.
Fill the jug (2) halfway with water, add a few
drops of dishwashing soap and follow the
steps as described (Fig. H).
The same procedure applies for the Smoot-
hie2Go bottle (13).
For best results, run the CLEAN program
immediately after use. Make sure to thoroughly
rinse and air-dry the jug after completion of the
program.

Troubleshooting Guide

Problem
Blender does not operate
Liquid is splashing out of the
jug
Motor base is moving on the
countertop
Deep Cleaning
We recommend to perform a deep cleaning of
the jug on a monthly basis using a vinegar solu-
tion to remove food residues and stains.
Prepare the vinegar solution in the jug : dilute
500 ml of vinegar (5% acid) in 500 ml of water
(1:1 ratio) and start the CLEAN program. Allow
the mixture to stand in the jug for maximum
5 minutes. Rinse the jug well after each deep
cleaning and allow it to air dry.

Warranty and Service

For
rate warranty and service leaflet or visit
www.braunhousehold.com.
Please do not dispose of the product
in the household waste at the end
of its useful life. Disposal can take
place at a Braun Service Centre or at
appropriate collection points provi-
ded in your country.
Materials and accessories coming
into contact with food conform to
EEC regulation 1935/2004.
Potential causes
No power supply
Jug or Smoothie2Go attach-
ment is not attached properly.
Timer shows three dashes
(- - -)
Gasket is not mounted pro-
perly, loose, or even torn
Jug lid or measuring cap are
not closed properly
Jug is overfilled
Rubber feet are not clean
detailed information
Solution
Check the fuse/circuit brea-
ker in your home. If none of
the above works, contact
Braun Customer Service
Check the correct position of
the attachment
Ensure that gasket is moun-
ted properly
Close the lid and measuring
cap
Follow the maximum quantity
recommendation in the pro-
cessing table
Clean the rubber feet to
ensure a good grip
see sepa-
13