GLW MC 25 Operating Manual page 56

TROUBLE-SHOOTING
2. Remove the tool insert
 Slide back the cover (1).
 Pull out the bolt (2).
 Press lower stripping cutter (3) upwards and
remove the tool insert (4) sideways.
 Remove end sleeve (5).
 Bend cable aside (6)
3. Remove the cable
 Pull the pin (1) upwards and pull out the end
sleeves (2).
 Close the cover (3).
 Connect mains cable (4).
 Turn on (position I) the mc 25 with the mains
switch (5).
 Press the reverse button (6) to move the mc 25
into start position.
 Pull out the cable (7).
After mounting the tool insert and insertion of the end sleeves the mc 25 is ready for operation.
18
Diagram 21 Remove the tool insert
Diagram 22 Remove the cable
10/12