GLW MC 25 Operating Manual page 48

COMMISSIONING
4. Fit the end-sleeve feeder
Verify that the tool insert is not
!
installed yet.
 Slide the cover (1) back.
 Insert the end-sleeve feeder (2) sideways and
place it on the bolts (3).
!
Check that the end-sleeve feeder has
clicked properly into place.
5. Mount the dispenser
 Mount the dispenser (1) on the holder.
Check that the dispenser has clicked
!
properly into place.
6. Mount the tool insert
 Take the tool insert with proper cross-section
and bolt from the accessories box.
Observe to the colour code of the tool
!
insert.
 Mount the tool insert (1) sideways.
 Fit the bolt (2) into the hole until it stops.
10
Diagram 5 Fit the end-sleeve feeder
Diagram 6 Mount the dispenser
Diagram 7 Mount the tool insert
10/12