LENCO L-92 User Manual page 10

ANTI-SKATING ADJUSTMENT
The anti-skate adjustment prevents the TONEARM ASSEMBLY from skipping across the record from the centrifugal
force that is caused spinning rotation of the PLATTER. The ANTI-SKATING control knob should be set to the same
value as the stylus pressure. For example if your COUNTERWEIGHT is set to 3 grams the ANTI-SKATE value should
also be set to 3.
PICKUP SELECTOR
LINE / PHONO SELECTOR IS LOCATED AT THE BACK PANEL.
-
SELECT "PHONO", AUDIO SIGNAL WILL BY PASS INTERNAL PRE-AMPLIFIER WITHOUT ANY PROCESSOR. THEN
-
TURNTABLE HAS TO BE CONNECTED WITH EXTERNAL PRE-AMPLIFIER OR PHONO CONNECTOR OF AN AMPLIFIER
IF AVAILABLE FOR MUSIC PLAYBACK.
SELECT "LINE", AUDIO SIGNAL WILL BE PROCESSED BY INTERNAL PRE-AMPLIFIER. TURNTABLE CAN BE DIRECTLY
-
CONNECTED WITH AN ACTIVE SPEAKER OR LINE IN CONNECTOR OF AN AMPLIFIER FOR MUSIC PLAYBACK.
-
REMOVE THE STYLUS PROTECTOR.
-
BE SURE THAT THE TONE ARM IS BEING DETACHED FROM THE TONE ARM REST PART BEFORE OPERATING AND
RE-SECURED AGAIN AFTERWARDS.
-
PUSH THE LIFT LEVER UPWARD TO RAISE THE TONE ARM FROM THE ARM PARK, AND THEN SLOWLY MOVE IT
TO THE RECORD SIDE. THE PLATTER WILL START TO ROTATE.
-
PUT DOWN THE LIFT LEVER TO DROP THE TONE ARM AND TOUCH THE RECORD GENTLY. PHONO PLAYING STARTS
NOW.
-
PUSH THE LIFT LEVER UPWARD TO RAISE THE TONE ARM FROM THE ARM PARK, NOW PLATTER WILL STILL BE
ROTATING BUT PHONO PLAYING WILL STOP. TO CONTINUE THE PLAYING, THE USER NEEDS TO PUT DOWN THE
LIFT LEVER.
-
TURN SPEED SELECTOR TO 33RPM OR 45RPM, DEPENDING ON THE RECORD TO BE PLAYED.
-
TURN START / STOP SWTICH TO STOP TURNTABLE FROM ROTATING OR RESUME TO WORK.
-
STROB DOTS ON THE TURNTABLE PLATTER FOR SPEED CHECKING. UPPER ROWS OF BIGGER DOTS FOR 33RPM,
UPPER ROWS OF SMALLER DOTS FOR 45RPM. ADJUST SPEED BY PITCH CONTROL SLIDER (+/-50%) IF NECESSARY.
SUITABLE DOTS WILL KEEP STABLIZED UNDER STROB LIGHT IF THE SPEED IS CORRECT.
10