Procedure 11 - Sideguards - Sunrise Medical RGK HILITE User Manual

Hilite User Manual | Procedure 11

Procedure 11 - Sideguards

Sideguards support the user and prevent clothes from getting dirty. Although these need little maintenance, replacement is
shown below.
11.1: Screw in sideguards
Remove the rear wheels. Using a 4mm allen key from the
toolkit, release the 3 screws in the sideguard. To install, secure
all screws but do not tighten until all are in position. Take care
not to cross thread the screws.
Fig 20.
11.2: Lift out sideguards
Remove sideguards from receiver. Using a 4mm allen key
from the toolkit, release the 2 screws securing the sideguard
to the lift out post. To install, replace and tighten the 2
screws. Take care not to cross thread the screws.
Fig 21.
18
11.3: Fold flat sideguards
Using a 3mm allen key from the toolkit, remove the 4 screws
from the inside of the sideguard. To install, secure all screws
but do not tighten until all are in position. Take care not to
cross thread the screws.
Fig 22.
11.4: Flip back sideguards
Using a 4mm allen key from the toolkit, release the screws
securing the sideguard to the lift out post. To install, replace
and tighten the 2 screws. Take care not to cross thread the
screws.
Fig 23.
Hilite User Manual
UM-Hilite-020-EU