Giving Priority To Shutter Speed (Shutter-Priority: Tv); Giving Priority To The Aperture (Aperture-Priority: Av) - Canon XL 1s Instruction Manual

Giving priority to shutter speed (shutter-priority: Tv)

E
Use this program to let you select the shutter
speed.
The camera sets the appropriate aperture
(F number) automatically to give the correct
exposure.
When you turn the POWER dial to Tv, the current
shutter speed is shown in the viewfinder. Select
your desired shutter speed by pressing the
r t
SHUTTER and
You can choose 12 shutter speeds between 1/8 and 1/15,000 of a second and also CS (Clear Scan) mode.
• If you try to set a shutter speed that is either too high or too low for the shooting conditions, the indicator
flashes in the viewfinder. In this case, increase or decrease the setting until the flashing stops, or slide the
ND FILTER switch ON/OFF as appropriate before changing the setting.
Note:
• When recording in extreme low-light conditions, we recommend the use of a Canon Speedlite or Video
Light (available as optional accessories, see page 60).

Giving priority to the aperture (aperture-priority: Av)

Use this program to let you select the aperture (iris
diameter) to give you maximum control over the
depth of field.
A large F number (a small aperture) gives a greater
depth of field.
• Under very bright conditions when you have set the F number to f/16, blurring of the image may occur.
Check the image in the viewfinder while setting the aperture.
• When a lens that has a built-in ND filter is attached, if you switch the filter on, the intensity of the light is
reduced and the image in the viewfinder may go dark. In such a case, switch the filter off and change the
aperture setting.
• When shooting in the [ (Easy Recording) or n (Auto) programs on bright sunny days outdoors, the
camera may display "ND ON"/"ND OFF" repeatedly. In this case, it may be effective to switch to the Av
recording program and adjust the setting of the F number to between f/5.6 and f/11 (the shutter speed may
become higher than usual).
The camera sets the appropriate shutter speed automatically to give the correct exposure. When you turn the
POWER dial to Av the current F number is shown in the viewfinder. Select your desired F number by
turning the IRIS/SELECT dial.
You can choose 8 F numbers between f/1.6 and f/16, and CLOSE to shut the iris completely. If you try to
set an F number that is too high or too low for the shooting conditions, the indicator flashes in the
viewfinder. In this case, increase or decrease the setting until the flashing stops.
Note:
• The camera memorizes the latest Tv or Av value until a new value is set except when you change the
exposure after locking the exposure.
Turning off the camcorder or changing the recording program does not erase the stored value.
50
buttons.
Tv 1000
Tv
Av F2.8
Av