Canon MV930 Instruction Manual page 111

Memory Card Related Messages
Message
NO CARD
THE CARD IS SET FOR
ERASURE PREVENTION
NO IMAGES
CARD ERROR
CARD FULL
NAMING ERROR
UNIDENTIFIABLE
IMAGE
TRANSFER
ORDER ERROR
CANNOT TRANSFER!
THIS IMAGE CANNOT
BE RECORDED
TOO MANY STILL
IMAGES DISCONNECT
USB CABLE
Memory card not is inserted into the camcorder.
SD Memory Card is set for erasure prevention. Replace the card
or change the position of the protect switch.
No images are recorded on the memory card.
A memory card error occurred. The camcorder cannot record or
play back the image.
The error may be temporary. If the message disappears after 4
seconds and " " flashes red, turn the camcorder off, remove
the card and reinsert the card. If "
continue recording/playback.
No remaining capacity on the memory card. Replace with another
card or erase images.
File or folder number has reached the maximum value.
Image is not recorded with JPEG compression, or with a
compression not compatible with the camcorder, or the image file
is corrupted.
You attempted to set more than 998 transfer orders.
You attempted to transfer a movie file as wallpaper.
Some analog images cannot be recorded on the memory card
depending on the signal.
Disconnect the USB cable and decrease the number of still
images on the memory card to less than 1800. If a dialog
appeared on the computer screen, close it. Reconnect the USB
cable.
Explanation
" changes to green, you can
E
81
81
–
–
–
84
–
106
105
–
–
111