Table of Contents
Advertisement
number appears and the inscription "REP", while the all-new calls that have occurred since the last check will look
"NEW" at the top of the display and the NEW blinks.
The followingRed all the symbols have their meanings:
"- P -" is a private conversation (limited number),
"- O -" is a call of the telephone service.
"- E -", the number that sent the call is incorrect
The device can store information of up to 99int rare numbers.
Incoming call register control
To view a list of incoming calls, press [Up] or [Down].
It will display the number and information on the call. To remove the caller number from the current list, press
[Del]. If you want to delete the entire list, press [Del] button for 3 seconds.
Redial
From the call list, select the desired number using the keys [Up] or [Down] and press [SPEAKER] or pick up the
handset and the phone will automatically select the number.
Additional phone features
Direct Memory Call
Schedule buttons
Select the number you want to save or select it from incoming calls or outgoing calls.
When the number is being read will be displayed on the screen, click [Store] and then press the quick dial [M1]
button. The number is stored.
Select a preset phone number to select a preset
number:
- Press the speed dial button [M1] or lift the machine from the fork and press the quick dial button, [M1].
The scheduled number is called automatically.
Tip: To delete a default number, it must be rescheduled.
Setting the alarm / ALARM
The device has the ability to store five alarms, which are activated at the indicated time. To set an
alarm:
• With your phone in the fork, press [ALARM]
• press [ALARM] again to select the alarm number (1 to 5) you want to set
• Use the [Up] or [Down] buttons to set the alarm. When the alarm is activated, the screen will show the symbol
(ALM), then confirm by pressing the [SET] button • If you want to abandon the settings, press [Del].
Note: When using alarm 1, 2, 3, the alarm will start every day at the specified time.
Alarm 4, 5 is set only at one time (without daily repetition).
Operation on the speaker
The phone can also work by switching the call directly to the speaker. In this case, the talk is heard all over the
room (no longer heard in the device). Press the button
For a good signal clarity, the maximum distance from the microphone of the device must be 50 cm. You can
adjust the call volume bypassing on the keys [Up] or [Down].
to switch on the speaker.
7
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the KXT-709 and is the answer not in the manual?
Questions and answers
Cannot get the KXT709 to work
@David Is there a video for setting up KXT709
To troubleshoot the Maxcom KXT-709 and get it to work, follow these steps:
1. No sound: Ensure the phone line is properly plugged into the correct slot.
2. Cannot make calls:
- Check if the dialing mode is set correctly (Pulse or Tone).
- Ensure the “Call Baby” Interference function is not enabled.
- Inspect the cables for damage and confirm the plug is securely connected.
3. Dark or unreadable display: Adjust the screen contrast or replace the batteries.
4. No ring tone when receiving calls: Make sure the doorbell (ringer) is properly seated.
5. Most functions not working: Check if the batteries are fully charged or need replacing.
6. General safety:
- Avoid moisture and extreme temperatures.
- Do not insert objects into the device.
- Do not open or attempt to repair the device yourself.
If problems persist, consult a specialized service technician.
This answer is automatically generated