Operation; On/Off Switch - Golden Eagle 5040 Owner’s Instruction And Operation Manual

NEVER OPERATE THIS PRODUCT WHILE UNATTENDED
PANEL CONTROLS
The blowers and automatic fuel supply are controlled
from a panel on this unit. The control panel functions are
as follows.

ON/OFF SWITCH

• When pushed the stove will automatically ignite. No
other firestarter is necessary. The igniter will stay on
for at least 10 and up to 15 minutes, depending on when
Proof of Fire is reached. The fire should start in about
5 minutes.
• The green light located above the On/Off button (in
the On/Off box) will flash during the ignition start-up
period.
• The Feed Rate Advance is inoperable during the ignition
start period. When the red light continuously stays on
the Feed Rate Advance can be adjusted to achieve the
desired heat output.
NOTE: If the stove has been shut off, and you want to re-
start it while it is still warm, the "On/Off" button must be
held down for 2 seconds.
© 2021 United States Stove Company
FUEL FEED SWITCH
• When the "Fuel Feed" button is pushed and held down
the stove will feed pellets continuously into the burnpot.
• While the stove's auger system is feeding pellets the
amber light (in the "Fuel Feed" box) will be on.
CAUTION:
DO NOT USE THIS CONTROL DURING NORMAL
OPERATION BECAUSE IT COULD SMOTHER THE
FIRE AND LEAD TO A DANGEROUS SITUATION.
HIGH FAN SWITCH
• The room air fan speed varies directly with the feed
rate. The "HIGH FAN" switch overrides this variable
speed function. It will set the room air blower speed to
high at any feed rate setting.
• When the "High Fan" button is pushed the room air fan
will switch to its highest setting.
• When this button is pushed again the room air fan will
return to its original setting based on the Feed Rate
Advance setting.
RESET TRIM
Different size and quality pellet fuel may require
adjustment of the "1" feed setting on the Feed Rate
Advance bar graph. This is usually a one-time adjustment
based on the fuel you are using. The "Reset Trim" button
when adjusted will allow for 3 different feed rate settings
for the #1 feed setting only. To adjust simply push the
"Reset Trim" button while the stove is operating at setting
"1" and watch the bar graph.
• When the "1" and "3" lights are illuminated on the
bar graph the low feed rate is at its "lowest" setting.
(approx. 0.9 pounds per hour)
• When the "1" light is illuminated on the bar graph the
low feed rate is at its "normal" setting.
• When the "1" & "4" lights are illuminated on the bar
graph the low feed rate is at its "highest" setting.
NOTE: When the stove is set on "1" the "reset trim" values
will be shown on the Feed Rate Advance bar graph. For
example if the Reset Trim is set to its lowest setting every
time the stove is set to low the "1" and "3" lights will be
illuminated on the bar graph.
10

OPERATION