Brother P-Touch 2450DX User Manual page 112

Error Message
LENGTH
LIMIT!
LINE
LIMIT!
MEMORY
FULL!
NO
FILES!
OVERFLOW
REPLACE
BATTERIES!
ROM
PROBLEM!
SET 24mm!
108
Cause
• This message appears if the text is
longer than 1 metre when you try to
print.
• This message appears if the Length
function is used to set a label
length that is less than 4.0 cm or
more than 30.0 cm.
• This message appears if the Tab
Length function is used to set a tab
length that is more than 30.0 cm.
This message appears if the number
of lines in the text is greater than the
maximum number of lines possible
for the installed tape.
This message appears if you try to
store a text file after 2500 characters
have already been stored in the
memory.
This message appears if you try to
recall or delete a text file from the
memory when none are stored.
This message appears if the calcu-
lated Euro conversion result exceeds
10 digits.
This message appears if the installed
alkaline batteries are about to run
out.
This message appears if there is a
problem with the machine's read
only memory.
This message appears if a 24-mm-wide
tape cassette is not installed when an
Auto Format layout for a 24-mm-wide
tape is selected.
Remedy
• Shorten the text to less than 1
metre before trying to print.
• Set the label length between
4.0 cm and 30.0 cm.
• Set the tab length so that it is
less than 30.0 cm.
Reduce the number of lines or
install a tape of greater width.
Delete an unwanted file to make
room for the new one.
Store a text file first.
Enter a smaller value.
Replace the batteries or use the
AC adapter.
Turn off the machine, and then
while holding down c and
R, turn the machine back on.
Contact your service representa-
tive.
Install a 24-mm-wide tape cas-
sette.