Suzuki DF150AP Owner's Manual page 59

NOTE:
• When pushing the SELECT switch to select
station, continue to push SELECT switch until
the buzzer sounds one short beep.
• If equipped with Keyless Start System:
If failed to switch from the 2nd station to the
1st station, operate the main switch to turn
the Keyless Start System to OFF state and
wait for 20 seconds, and then turn it back to
ON state again.
If not equipped with Keyless Start System:
If selecting the 1st station returning from the
2nd station is failed, turn OFF the main
switch then turn ON it after 20 seconds past.
• Consult your authorized Suzuki marine
dealer if the station can not be selected.
Throttle Only Switch
This switch holds the shift position in neutral,
thereby allowing operation the throttle without
changing the shift position. When the shift posi-
tion is hold in neutral, the THROTTLE ONLY
LED comes on and when the switch is
released, the THROTTLE ONLY LED goes out.
The throttle only switch is only enabled when
the remote control handle is in the neutral posi-
tion.
NOTE:
If this switch is operated with the remote control
handle in a position other than neutral, the
THROTTLE ONLY LED blinks and a buzzer
sounds at the same time.
NOTE:
• When selecting the THROTTLE ONLY mode,
continue to push the THROTTLE ONLY
switch until the buzzer sounds one short
beep.
• If equipped with Keyless Start System:
If the THROTTLE ONLY mode cannot be
selected, operate the main switch to turn the
Keyless Start System to OFF state and wait
for 20 seconds, and then turn it back to ON
state again.
If not equipped with Keyless Start System:
If it is not possible to out the THROTTLE
ONLY mode, turn OFF the main switch then
turn ON it after 20 seconds past.
• Consult your authorized Suzuki marine
dealer if the THROTTLE ONLY mode can not
be selected.
Engine Synchronize Switch
On dual or triple engine installation, this is a
switch to synchronize or unsynchronize the eig-
ine speed with the port side engine.
On quadruple engine installation, this is a
switch to synchronize or unsynchronize the
engine speed with the port side engine on two
engine groups. Two engine groups don't syn-
chronize each other.
Engine speed is synchronized in forward cruis-
ing. When the engine speed is synchronized,
the SYNC LED comes on and, when the engine
speed is unsynchronized, the SYNC LED goes
out.
Synchronization does not take place in idle
speed and full throttle operation.
59