Fuses - Jeep WRANGLER RUBICON 392 2021 Features Manual

28 SERVICING AND MAINTENANCE
Engine Air Cleaner Inspection and
Replacement
Follow the recommended maintenance
intervals as shown in the Maintenance
Schedule in this section.
Engine Air Cleaner Removal
1. Loosen the fasteners from the air cleaner
cover using a suitable tool.
Engine Air Cleaner Cover
1 — Engine Air Cleaner Cover
2 — Fasteners
2. Lift the engine air cleaner cover to access
the engine air cleaner.
3. Remove the engine air cleaner from the
housing assembly.
Engine Air Cleaner Installation
NOTE:
Inspect and clean the housing if dirt or debris is
present before replacing the engine air cleaner.
1. Install the engine air cleaner into the
housing assembly with the engine air
cleaner inspection surface facing
downward.
2. Tighten engine air cleaner cover fasteners
using a suitable tool.
F
USES
General Information
WARNING!
When replacing a blown fuse, always use

an appropriate replacement fuse with the
same amp rating as the original fuse. Never
replace a fuse with another fuse of higher
amp rating. Never replace a blown fuse with
metal wires or any other material. Failure to
use proper fuses may result in serious
personal injury, fire and/or property
damage.
Before replacing a fuse, make sure that the

ignition is off and that all the other services
are switched off and/or disengaged.
If the replaced fuse blows again, contact an

authorized dealer.
If a general protection fuse for safety

systems (air bag system, braking system),
power unit systems (engine system,
gearbox system) or steering system blows,
contact an authorized dealer.