Jeep WRANGLER RUBICON 392 2021 Features Manual page 29

NOTE:
The captured fasteners are made to stay with
the first water separation chamber and must
NOT be removed.
2. Pull on the hood duct at the top to
disengage the push pin clip along with the
rubber grommet and remove from vehicle.
First Water Chamber Removal
Installation
NOTE:
Inspect and clean the housing if dirt or debris is
present before replacing.
1. Locate the first water separation chamber
to hood/second chamber then engage the
push pin clip and grommet.
First Water Separation Chamber
1 — Push Pin
2 — Grommet (On The Backside)
SERVICING AND MAINTENANCE
NOTE:
Both components should click in. The cone
shaped to the second chamber can aid in
locating parts.
2. Hand start the six captured fasteners.
3. Tighten the captured fasteners, do not
over-tighten.
27
4