Refrigerator Alignment - Westinghouse IK009 Installation Manual

12 westinghouse.com.au
INSTALLATION (CONTINUED)

REFRIGERATOR ALIGNMENT

Position the refrigerator in the cupboard so that:
1. Top hinge bracket is against cupboard wall
(Figure 8).
. 2
Front of refrigerator cabinet (with doors open)
is parallel to and approximately 100mm from the
front of the cupboard (Figure 9).
. 3
Position bottom location brackets as shown
(Figures 9 & 9a). Fit foot in appropriate hole as
shown and level refrigerator. (Figure 10).
NOTE: Do not screw in place yet.
For improved aesthetic we suggest painting
the brackets to match the colour of the
cupboard floor.
NOTE: The front adjustable rollers may need
raising (rotate anti-clockwise when viewed
from above) to achieve this.
Figure 8
Fridge
Top Hinge Bracket fitted – note the space between
the cupboard and the side of the refrigerator is to be
approximately 85mm.
Figure 9
100mm
85mm
Figure 9a - Hinge side
Figure 10
Height
adjustable
roller
. 4 Slowly close the cupboard door (pushing the
refrigerator back) until it is slightly ajar, i.e.
with a gap of about 4mm (Figure 11).
You may have to reposition the refrigerator back or forward
until the 4mm gap is obtained. Ensure that the refrigerator
remains parallel as you do this. Once you have the correct
gap, proceed to the next step.
Figure 11
4mm
NOTE: The gap is left to ensure the refrigerator door will be
allowed to close fully for a good gasket seal.
Stability foot
hinge gap