Titan HPE-L Instruction Manual page 13

7.1. Adjusting strap width
The strap guide (n) located next to the feed wheel is replaced when the strap width is
modified. In order to do so the safety ring has to be removed by means of a
screwdriver and the lifting lever (c) and the cutting lever (b) pressed together. The
strap guide may now be pulled off toward the front and be replaced with the strap guide
for other strap widths. Replace safety ring afterwards.
Strap width 13 mm, order no. 2240001-500
Strap width 16 mm, order no. 2240001-501
Strap width 19 mm, order no. 2240001-502
Since the strap is guided at three points in the tool the rear strap guide (l) and the
adjusting screw (m) also have to be set in such a way that the punching is placed at
the centre of the strap.
In order to do this, loosen the two fastening screws for the rear strap guide and the
lock nut of the adjusting screw. The lock nut is located behind the plastic cover of the
housing. Tighten lock nut and fastening screws after adjustment has been completed.
Adjustment can be made easier by using a setting gauge or two strips of the strap
inserted into the HPE.
m n l
HPE
H 224 EU 21/06