Titan HPE-L Instruction Manual page 11

6.
Bring cutting lever (b) back into its initial
position and take hold of the cut off strap end
with your left hand. Lift the compressed air motor
(f) up to the limit and swing the tool to the
right out of the strapping.
The following picture shows a correctly carved seal.
Check the seals regular:
for even carved cuttings,
for neat cutting edges,
for that the lower run of strap is soaked in the cuttings,
for correct adjustment of the cutter,
for a sufficient overlap of the lower run of strap and
for that the seal is placed in the centre of the strap.
HPE
H 224 EU 07/10