Assembling The Pole Pruner - Stihl HTA 135 Instruction Manual

English

7 Assembling the Pole Pruner

7.1 Assembling the Pole Pruner
► Switch off the pole pruner and remove the battery.
2
b
► Remove the protective cap (1).
► Adjust the shaft length to a = 10 cm.
► Mark b = 6 cm on the shaft (2).
4
90°
► Align the collet (4) and transmission (3) as shown.
► Slide the transmission (3) onto the shaft (2) up to mark b.
► Tighten down the screws (5) firmly.
16
1
a
3
5
3
90°
8
6
7
► If you cannot push the transmission (3) onto the shaft (2)
up to mark b:
► Rotate the nut (7) counterclockwise until the chain
sprocket cover (6) can be removed.
► Remove the chain sprocket cover (6).
► Turn the chain sprocket (8) and push the transmission
(3) onto shaft (2) up to mark b.
► Fit the chain sprocket cover (6) so that it is flush with the
pole pruner.
► Fit the nut (7) and tighten it down firmly.
► Undo the screws (9).
► Pull out the protective tube (10).
7 Assembling the Pole Pruner
9
10
0458-698-0121-A