Honda VT1300CR/CRA Manual page 68

Engine Oil u Changing Engine Oil & Filter
6. Remove the oil filter with a filter wrench
and let the remaining oil drain out. Make
sure the prior seal is not stuck to the
engine.
u Discard the oil and oil filter at an
approved recycling center.
Oil filter
66
7. Apply a thin coat of engine oil to the
8. Install a new oil filter and tighten.
9. Install a new sealing washer onto the
Rubber seal
10. Fill the crankcase with the recommended
11. Check the oil level.
12. Check that there are no oil leaks.
rubber seal of a new oil filter.
Torque: 19 lbf·ft (26 N·m, 2.7 kgf·m)
drain bolts. Tighten the drain bolts.
Torque: 22 lbf·ft (30 N·m, 3.1 kgf·m)
oil ( ) and install the oil fill cap/
P. 47
2
dipstick.
Required oil
When changing oil & engine oil
filter:
3.9 US qt (3.7 liters)
When changing oil only:
3.7 US qt (3.5 liters)
2
P. 63