Installation; Positioning The Unit; Installation Modes; Minimum Installation Distances - Carrier 42SIC Installation, Operation And Maintenance Instructions

2 - INSTALLATION

2.1 - Positioning the unit

Avoid installing the unit in proximity to:
- positions subject to exposure to direct sunlight;
- in proximity to sources of heat;
- in damp areas or places with probable contact with water;
- in places with oil fumes
- places subject to high frequencies.
Make sure that:
- the wall on which the unit is to be installed is strong enough to support the weight;
- the part of the wall interested does not have pipes or electric wires passing through;
- the interested wall is perfectly flat;
- there is an area free of obstacles which could interfere with the inlet and outlet air flow;
- the installation wall is preferably an outside perimeter wall to allow the discharge of the condensation outside;
- in case of ceiling installation the airflow is not directed towards persons.

2.2 - Installation modes

The following descriptions of the various mounting phase and the relative designs refer to a version of the machine with fixtures on
the left.
The operations for the mounting of machines with fixtures on the right are exactly the same.
Only the images are to be considered as a mirror image.
To ensure that the installation is performed correctly and that the unit will perform perfectly carefully follow the instructions indicated
in this manual. Failure to respect the rules indicated not only can cause malfunctions of the unit but will also invalidate the warranty
and hence CARRIER shall not respond for any damage to persons, animals or property.

2.3 - Minimum installation distances

Figure indicates the minimum mounting distances between the wall-mounted cooler-convector and furniture present in the room.
5